:	Jul 23, 2004

.

Disconnect the battery ground cable.

.

: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands. Raise and support the vehicle.

.

Remove the transmission heat shield.   Remove the four retaining bolts.

.

Release the selector cable from its abutment bracket.

.

Remove the transmission heat shield bracket.   Remove the four retaining bolts.

.

Drain the transmission fluid.

.

: Protect the engine during this operation. Raise the RH side of the engine by approximately 35 mm (1.38 in).   Use a transmission jack.   Remove and discard the two retaining bolts.

.

Remove the fluid pan, gasket and filter.   Position a container to collect the fluid spillage.   Remove the 21 Torx screws.   Remove and if necessary, discard the seal.   Discard the O-ring seal.

.

Install the fluid pan, gasket and filter.   Clean the components mating faces.   Install a new O-ring seal.   Tighten the Torx screws to 8 Nm (6 lb.ft).

.

Lower the RH side of the engine.   Remove the transmission jack.   Install new engine mounting retaining bolts and tighten to 45 Nm (33 lb.ft).

.

Install the transmission heat shield bracket.   Install the four retaining bolts and tighten to 10 Nm (7 lb.ft).

.

Install the selector cable to its abutment bracket.

.

Install the transmission heat shield.   Install the four retaining bolts and tighten to 10 Nm (7 lb.ft).

.

Connect the battery ground cable.

.

Refill the transmision with fluid.